What this audio normalizer does
LouderKit's audio normalizer sets each file to the same loudness. It is built for the everyday case where files that belong together play at different volumes: songs from different albums, podcast episodes recorded on different days, or lectures recorded from different seats. Instead of riding the volume control, you normalize them once and they play back at the same level everywhere.
Every file is measured with the loudness method from ITU-R BS.1770, the method streaming services and broadcasters use. The normalizer then raises or lowers the whole file by the amount needed to reach your target. Quiet files go up, loud files come down, and the shape of the sound inside each file stays the same.
Loudness normalization vs peak normalization
| Loudness (LUFS) | Peak (−1 dB) | |
|---|---|---|
| What it measures | How loud the file sounds over its whole length | The single loudest sample |
| Result across files | Files sound equally loud | Loudest peaks match, but files can still sound very different |
| Use it for | Playlists, podcasts, videos, lectures | Making one quiet file use the full range without changing its character |
Most people who search for an audio normalizer want files that sound equally loud, so loudness is the default here.
Which target should you use?
| Target | Where it fits |
|---|---|
| −14 LUFS | Music and video for streaming sites and YouTube; good for phones and computers |
| −16 LUFS | Podcasts, audiobooks and other spoken audio |
| −23 LUFS | Broadcast work that follows the EBU R128 recommendation |
| Peak −1 dB | When you only want the loudest peak raised to just below the top |
Streaming services turn loud tracks down to their own reference level, so normalizing louder than about −14 LUFS rarely makes a file sound louder there. If you want one file as loud as possible, use the audio volume booster and its Maximum mode instead.
Why peaks stay below −1 dB
Raising a file by a fixed amount can push its loudest moments past the top of the digital scale, where they get cut off and crackle. The normalizer uses the same look-ahead limiter as the LouderKit volume booster: it lowers the volume smoothly for just those moments, so the result stays below −1 dB true peak. The list shows the peak and the clipped-sample count for every file, so you can check it.
For a file with very sharp peaks, holding the peaks back can leave the file slightly below the target. LouderKit then makes one extra pass to get closer, and tells you which files still landed short.
Normalizing many files at once
- Batch size: up to 50 files on a computer and 20 on a phone. Files are processed one at a time to keep memory use low.
- Saving: each file has its own Save link, and Download all puts every finished file into one ZIP.
- Changing the target: pick a different target or format and the whole list is processed again.
Supported files and limits
- Audio formats: MP3, WAV, M4A, AAC, OGG, Opus, FLAC and AIFF, as long as your browser can decode the format.
- Output: MP3 at the bitrate of each original (128–320 kbps) or 16-bit WAV.
- Size: up to about 80 MB per file on phones and 600 MB on computers.
- Videos: to make the sound of a video louder and keep the picture, use the volume booster for video.
Your files stay on your device
Everything happens in your browser tab. The files are not uploaded, stored or seen by anyone. If something does not work, see LouderKit help or write to us on the contact page.